Filter & Conditioner Modules

 

NL125-6–Band-Pass-Filter-digitimer

 

NL125/6 – Band-Pass Filter
The NL125/6 band-pass filter module employs two active sections to control the high and low pass characteristics. The low frequency cutoff point can be set continuously from 0.5Hz to 5kHz with a single turn potentiometer, in four switched ranges. Similarly the high frequency cutoff can be set continuously from 5Hz to 50kHz in four switched ranges. DC and WB (wide band) switch positions by-pass the lower and upper filter sections, respectively.

NL134-5-6–Four-Channel-Low-Pass-Filters-digitimer

 

NL134/5/6 – Four Channel Low Pass Filters
The NL134/5/6 FILTERS are 4-channel, second order (two-pole) low-pass with mains frequency Notch reject (NL135/6 only) filter modules. They are ideal partners for the NL820 Isolated Amplifier system. The filter settings have been selected for most electrophysiological protocols but other frequencies can be factory set to order. A rotary switch selects the 14 frequency settings giving repeatability over a wide range….

NL143–Three-Channel-Difference-Amplifier-digitimer

 

NL143 – Three Channel Difference Amplifier
The NL143 is a 3-channel difference, or differential, amplifier with 4-channels of input. Internal selection allows the difference between any of the four input channels to be made. Internal preset controls (finger operated) allow an offset to be nulled or added as required. High input protection allows for signals coming from units that are not part of the NeuroLog System. This module allows the difference between two signals….

NL144–Four-Channel-High-Pass-Filter-digitimer

 

NL144 – Four Channel High Pass Filter
The NL144 is a 4-channel, second order (two-pole) high pass filter which complements the NL134/5/6 mentioned above. when used with the NL820A isolator, these module provide a compact solution to 4 channel high and low pass filtering.

NL530–Signal-Conditioner-digitimer

 

NL530 – Signal Conditioner
A single width module designed to give gain and offset set-up controls when interfacing signals to the analog-to-digital converters (ADCs) of PCs. The module contains four channels each with independently adjustable filter settings and front panel gain and offset presets. There is also a master ADC offset control to allow unipolar ADCs to be used with bipolar signals. As ADC boards have a precise input range (outside of which damage may occur)

NL540–Inverting-Attenuator-Alt.Gain-digitimer

 

NL540 – Inverting Attenuator (Alt. Gain)
The NL540 is a four channel NeuroLog System module that can be used with our amplifiers to attenuate and or invert up to four input signals. Inversion or attenuation can be:-
(i) Activated when the Manual/External Gain Control switch is moved from the NORM. to the ALT. position (MANUAL CONTROL).
(ii) Initiated and terminated (toggled) by successive TTL logic pulses at the External Trigger Input Socket (TTL PULSE CONTROL).

Translate »
MENU